The official Mender documentation explains how Mender works. This is simply a board-specific complement to the official documentation. Board description It’s an open-source single-board computer. It can run Android 4.2, Android4.4, Ubuntu, Debian, Fedora, Raspbian, ArchLinux,openSUSE, OpenWrt, and …

Hi, I built this image and it seems to boot. At early boot stage it says “failed to shut down host controller.” four times. But it continues with Loading device tree to 49ff8000, end 49fffd7a ... ok. And I think the next line says Loading kernel... but the HDMI output is cut on the left side. Then …

I ave same experience and found out that hdmi support if not enabled in meta-sunxi kernel. I have somewhere patch (I have it for some old kernel) but look for : CONFIG_DRM_SUN8I_DW_HDMI=y and other dependencies to enable HDMI output.

Thanks for the hint! And what about ssh? Can you login?

Are you able to get a raw connection to port 22 and see the SSH banner? If so then you probably just need to set the login credentials. Or just add “debug-tweaks” to EXTRA_IMAGE_FEATURES for it to have user root with no password.

Turns out that my crappy router firmware does not show the current IP address correctly. Found that out when cross checking with nmap. ssh works.

OrangePi PC Plus

Board Integrations Yocto Project

Topic		Replies	Views
OrangePi Zero Yocto Project yocto , orange-pi	22	9700	May 17, 2021
OrangePi Zero Plus2 General Discussions yocto	8	1561	October 9, 2020
NanoPi M1 Plus Yocto Project yocto , sumo , nanopi	4	3128	October 20, 2020
Raspberry Pi 3 Model B/B+ Yocto Project yocto , raspberry-pi , sumo , rocko , thud , warrior	3	28227	June 10, 2023
Orange-pi-zero General Discussions	8	1461	February 10, 2020

OrangePi PC Plus

Related topics