I am trying to get mender working with the rip compute module 3b+. The first thing I tried were these images here: Prepare a Raspberry Pi device | Mender documentation and also here: [image] Raspberry Pi 3 Model B/B+ Raspbian Debian family Board description The Raspberry Pi 3 Model B/B+ is a popular single board computer based on Broadcom SoCs. It is the most powerful board within the Raspberry Pi family and probably the most popular with “makers”. [770A5842-462x322] URL: https://www.raspberrypi.org/products/raspberry-pi-3-model-b-plus URL: https://www.raspberrypi.org/products/raspberry-pi-3-model-b Wiki: https://elinux.org/RPi_Hub Test results The Raspberry Pi OS releases in the table below have been tested by the Mender c… The cm 3b+ didn’t boot with these images. I also tried mender-convert with a fresh image: 2022-09-22-raspios-bullseye-armhf-lite With the original image, the cm3b+ boot just fine. But not with the mender converted image. I see momentarily the coloured screen and then blank. I also tried to see what on the part output. All I get is this message: U-Boot 2020.01-g83cf4883ec (Dec 08 2022 - 09:32:45 +0000) DRAM: 948 MiB RPI Compute Module 3+ (0xa02100) Maybe I need to change something because I am using the cm3 b+ and not the rpi 3 b+?

Just incase anyone is having the same issue, you have to built u-boot again for the correct device tree as there are different configs for the CM3 and the RPI3.

Mender-convert with rpi cm3 b+

Mender-convert with rpi cm3 b+