Hi There, I’m working through a problem trying the enable uart1 on my Compute Module 3 board. While doing so, I’ve been checking the device tree and am a little confused as to which device tree is used by u-boot. From what I can tell, U-Boot should be using the bcm2836_rpi_2_b.dts file. However, l…

Does mender change u-boot dts?

mirzak March 8, 2019, 2:21pm 4

Any suggestions?

Sorry, not much. I didn’t even know that you could have two uarts enabled at the same time on the Raspberry Pi 3.

Does this work with a stock image, e.g Raspbian?

Topic		Replies	Views
U-Boot error - Did not find a dtb specified in KERNEL_DEVICETREE General Discussions	3	2156	June 16, 2020
Pi3 not booting with bluetooth disabled General Discussions	3	493	March 17, 2022
Beaglebone + u-boot = multiple DTB in KERNEL_DEVICETREE warning - ok? General Discussions yocto , beaglebone-black , warrior , u-boot	5	2121	February 6, 2020
Meta-mender master rpi4 boot issue General Discussions	5	582	March 24, 2022
Updating Raspberry Pi boot firmware files using Yocto Project and Mender Mender	23	10051	February 17, 2023